Tune RigExpert for APRS program
This driver emulates two serial ports and provides communication between under Windows XP
184.108.40.206 allow using up to 10 pairs of emulated serial ports.
(click for downloand save extract to prepared folder)
Open "Control Panel"-"
Performance and maintenance"-"
Click "Add Hardware Wizard"
In Hardware Wizard box, click "Next"
Check “Yes, I have already connected the hardware” “Next”
From Hardware types list, select
"Add a new hardware device " and click "Next"
Choose "Multiport serial adapter"
Choose MixW serial port bridge
Click "Have Disk"Click "Browse" and locate ComEmulDrv.inf file
, from CD disc or folder and click "Open"(download driver
to prepared folder) (CD drive :\TNCemulation\driver\ComEmulDrv.inf)
Ignore sign and say "Continue Anyway"
Tuning COM ports
from Control Panel
Select "Hardware" tab
Click "Device Manager"
Locate "MixW serial port bridge"
under "Multi-port serial adapters"
Right-click onMixW serial port bridge and choose "Properties"
Select Properties tab
Choose first and second emulated ports for each pair (COM4 and COM5)
WARNING: Choosing ports which already exist may cause driver conflicts!
Click OK and reboot the computer Emulated ports
Start program click Setup - Comms Setup
COM port 4
Host mode - KISS
Baud rate - 9600
Data bits - 8
Stop bits - 1
click Options - SET TNC Com Port
Put Tick "Connect to TNC" and "Kiss Mode"
Tune MixW for Kiss mode
Start MixW program
Choose Packet mode
Open Mode settings
Install for VHF/UHF operation 1200 baud
for HF 300 baud
Tick "Emulate KISS on TNC emulation port"
Go to Configure TNC emulation.
MixW not switch off
Open program ozziAPRS or UI-View32
Start to receive
MixW waterfall allow you precise tune RX/TX frequency and make control at other staitions.